BES Express - stuck after SRP ID and Auth KEY
Ive been following the ZCB Guide relatively close, but its rather vague when you encounter something outside the norm.
Heres where I am stuck at:
Installing CDO, Outlook, and BES
Use the appropriate software documentation to install the following:
1. Install Microsoft Windows Server 2003 and the latest service packs.
2. Install Microsoft Exchange Server MAPI/CDO 1.2.1 and the latest service
packs.
3. Install BlackBerry Enterprise Server for Microsoft Exchange 4.1 or
BlackBerry Professional Software for Microsoft Exchange 4.1
Note: During the BES installation, after you enter your SRP information,
you may be prompted to enter profile creation information in a Microsoft
Exchange Server dialog. Press OK to skip this step. Ignore any
subsequent BES profile errors, such as an Invalid properties error.
Note: During the BES installation ignore warnings such as Exchange
Server is not detected errors or Could not verify the Microsoft Exchange
permissions errors.
So I ve started installing BES express Im at the SRP ID and Auth KEY, I hit next - I get "Microsoft Exchange Server" So per the guide, listed above, I click ok to skip.
"BESProfile Error - The (Blackberry Server) profile is invalid due to missing or invalid property" Yippie, the guide warned me so continue following the guide. Click Ok
Then I get "Blackberry CAL and SRP Information: The MAPI subsystem cannot be correclt initialized and used. Please make sure MAPI is installed and configured properly".
So I installed MAPI/CDO not a whole lot there than running the msi and clicking finish. So not sure on the configuration part. Back to the issue, so I click ok to the above error. It goes back to the BES Installation - Blackberry CAL and SRP Information Page.
Not sure what to do next.
Please advise.
BES connector for BESx 5.x.x
hi,
When will be available the Bes connector for BES Express 5.x.x?
thx.