Results 1 to 3 of 3

Thread: install.sh grinds to a halt... with unicode_start

  1. #1
    gregkattawar is offline Starter Member
    Join Date
    May 2006
    Posts
    2
    Rep Power
    8

    Exclamation install.sh grinds to a halt... with unicode_start

    I went through directions to the "t". Everything was going fine, until I got about 3/4ths of the way through the install.sh... Then it started cranking out tons of the unicode_start procs... until the machine basically just siezed up. I checked the /etc/hosts file and it was done as the notes said (localhost.localdomain localhost) with the 127.0.0.1 prefix...

    Now all I get is out of swap and things start getting killed off. It has run for hours...

    Any ideas/suggestions?

    thx

  2. #2
    bobby is offline Zimbra Employee
    Join Date
    Nov 2005
    Posts
    518
    Rep Power
    10

  3. #3
    gregkattawar is offline Starter Member
    Join Date
    May 2006
    Posts
    2
    Rep Power
    8

    Default

    commenting out the utf8 lines in the i18N file in sysconfig directory did the trick. Should have found that one sooner via search. My bad. Now on to ldap stuff.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •