Relay problem.

[jrmy]

I need to allow relay access to the zimbra server from an outside IP address.

I searched the forums and found some instruciton and I have set zimbraMtaMyNetworks to the correct ips/subnets.

When I run postconf mynetworks everything shows fine.

I restared zimbra but it did not work.

I tried to connect via telnet but the connection is terminated by zimbra.

Any idea?

[KevinH]

What does it show in the logs? Is it showing the right IP that you added to mynetworks when postfix handles the connection.

[jrmy]

I figured out what was wrong. I had put the full IP address in, instead of the network (.0) address. I was hoping to only allow a single IP instead of a whole block based off the subnet.

Is there any way to only allow a single IP?

[bobby]

if your ip is, for example, 10.2.3.4:

10.2.3.4/32

[jrmy]

That is what I tried but zimbra would just close the connection...