I need to allow relay access to the zimbra server from an outside IP address.
I searched the forums and found some instruciton and I have set zimbraMtaMyNetworks to the correct ips/subnets.
When I run postconf mynetworks everything shows fine.
I restared zimbra but it did not work.
I tried to connect via telnet but the connection is terminated by zimbra.
What does it show in the logs? Is it showing the right IP that you added to mynetworks when postfix handles the connection.
I figured out what was wrong. :) I had put the full IP address in, instead of the network (.0) address. I was hoping to only allow a single IP instead of a whole block based off the subnet.
Is there any way to only allow a single IP?
if your ip is, for example, 10.2.3.4:
That is what I tried but zimbra would just close the connection...