Quote:
|
Originally Posted by marcmac Sometimes, the ldap commands will not use DNS, where the system will - can you run:
host <hostname> on that hostname, and verify that it resolves in DNS? |
Would this also affect the authentication portion of the setup as well? because that works perfectly. In resolv.conf i have the IP address of the domain controller hosting ad.lsky.ca as the main domain server and I have verified that it works by performing nslookups.
If this is a DNS issue what else can I check to make sure everything is setup properly?
As far as the GAL setup goes I enter in my AD servers (in this case two, a primary and a backup - 10.196.161.10 and 10.196.161.11), I enter the bind dn of
administrator@ad.lsky.ca.