ZCS Administrator Guide 7.2.1
ZCS Administrator Guide 7.2.1
Open Source Edition


Working with Zimbra Proxy > Setting up IMAP/POP Proxy after HTTP Proxy

Setting up IMAP/POP Proxy after HTTP Proxy
Zimbra Proxy is installed with ZCS and is set up during Installation from the ZCS configuration menus. Zimbra proxy must be installed on the identified proxy nodes in order to set up HTTP proxy. No other configuration is usually required.
To set up IMAP/POP proxy after you have already installed Zimbra HTTP proxy, set up the Zimbra mailbox server and the proxy node as described in the following two sections.
Note:
You can run the command as zmproxyconfig -r, to run against a remote host. This requires the server to be properly configured in the LDAP master.
Setting Up IMAP/POP Proxy With Separate Proxy Node
When your configuration includes a separate proxy server follow these steps.
Setup Zimbra Mailbox Servers
1.
/opt/zimbra/libexec/zmproxyconfig -e -m -H mailbox.node.service.hostname
This configures the following:
2.
zmcontrol restart
Setup Proxy Node
1.
/opt/zimbra/libexec/zmproxyconfig -e -m -H proxy.node.service.hostname
This configures the following:
Setting Up a Single Node
When Zimbra proxy is installed along with ZCS on the same server, follow this step.
1.
/opt/zimbra/libexec/zmproxyconfig -e -m -H mailbox.node.service.hostname
This configures the following:
2.
zmcontrol restart
Copyright © 2012 VMware Inc.